Pulley Optimization and Maintenance Guide
In short. A cable machine needs servicing every 2 to 3 months: clean the pulleys and cables, then apply silicone lubricant or 3-in-1 oil to the bearings (in the centre, on the axis of rotation), to the cables if they are dry, to the axles and the carriage, and wipe off the excess. On a new pulley, a few uses are needed for the product to spread. Here is the detailed procedure.
Choice of lubricant: Use a silicone lubricant (e.g. WD40) or a lubricant such as 3-in-1 oil. These products reduce friction without attracting dust or debris.
Pre-cleaning: Before application, thoroughly clean pulleys and cables to remove any dirt or residue. This ensures better adhesion of the lubricant and prevents premature wear.
Lubricant application:
- Pulleys: Apply the lubricant to the bearings and surfaces in contact with the cables. Rotate the pulleys by hand to ensure even distribution of the product. For optimum lubrication of the bearings, it is recommended to apply the lubricant directly in the centre, at the axis of rotation. If possible, dismantle the bearing to carry out this operation. If your pulley is new, it is advisable to lubricate the bearings before fitting.
- Cables: If the cables show signs of dryness or excessive friction, apply a thin layer of lubricant along their entire length.
- Shafts and carriage: Apply the lubricant to the shafts and carriage, then use your pulley over its full range to distribute the product evenly. In our experience, if your pulley is new or has never been lubricated, it will take a few uses to distribute the lubricant evenly and make the movement as smooth as possible.
Wipe off any excess to prevent the lubricant from dripping or attracting dust.
Maintenance frequency: We recommend lubricating the pulleys and cables every 2 to 3 months, depending on how often your equipment is used. Intensive use may require more frequent lubrication.
To go further in the shop: Cable pulleys, Athena pulleys, Athena accessories.
The Uni Strength pulleys covered by this guide
| Type | Model | Key figure |
|---|---|---|
| Weight stack, rack-mounted | CS-1 high and low pulley, 90 kg stack | 5 kg steps, 1:1 ratio, for 204 and 236 cm CS-1 racks |
| Plate-loaded, free-standing | UF Athena adjustable pulley | 33 height settings, cables up to 130 kg, 206 cm high |
| Plate-loaded, compact | Plate-loaded adjustable pulley | 19 height settings, 130 kg maximum load, 63 x 63 cm footprint |
Specifications taken from the product pages on 10 October 2026.
Frequently asked questions
Which lubricant should you use on a cable pulley?
A silicone lubricant (WD-40 type) or a 3-in-1 oil: they reduce friction without attracting dust. Clean the pulleys and cables first.
Where should the lubricant be applied?
On the pulley bearings (at the centre, on the rotation axle), on the cables if they are dry, then on the guide rods and the carriage. Run the pulley through its full range and wipe off any excess.
How often should a pulley be serviced?
Every 2 to 3 months for regular use, more often for intensive use.
