CS-1 Compact Logo Upright

The CS-1 compact logo upright is a 104 cm crossmember in 3 mm steel with a 75 x 75 mm section that stiffens your CS-1 power rack and serves as a mounting point for accessories.

Technical specifications of the CS-1 Compact Logo Upright

• Length: 104 cm
• Width: 75 mm
• Steel: 3 mm thick

• Section: 75 x 75 mm, the CS-1 range standard
• Compatibility: CS-1 uprights, J-cups, safeties and storage
• Function: structural bracing and accessory mounting point
• Marking: cut-out Uni Strength logo

Structural bracing that carries the Uni Strength signature

The CS-1 Compact Logo Upright is a 104 cm crossmember that plays two roles on your power rack. It connects two uprights to stiffen the structure and it carries the Uni Strength logo, the finish that tells a carefully built setup apart from a pile of assembled parts.

At 104 cm, it mounts horizontally between two uprights, on the lower or middle part of the cage, where rigidity is actually decided.

A structural part, not a cover panel

This upright uses the same 3 mm steel and the same 75 x 75 mm section as the rest of the range. It is not a trim piece bolted onto the cage, it is a load bearing element. Added to your rack, it reduces play in the structure and absorbs the vibration of heavy sets.

And one more mounting point

Like the CS-1 uprights and crossmembers, it takes the accessories of the range. What was a brace becomes a storage mount, an anchor point or an extension, depending on the configuration you give it. A crossmember added today stays useful in the setup you will have in two years.

Usage and safety tips

• Tighten the hardware to the recommended torque and re-tighten after the first sessions, while the structure settles.
• Check that the crossmember is level and secured on both sides before loading the cage.
• Check the tightness periodically, as on the rest of your rack.

CS-1 uprights and crossmembers, which format to choose?

CS-1 uprights and crossmembers share the same 75 x 75 mm section and the same hole standard.

Unique benefits of the CS-1 Compact Logo Upright

• It stiffens the cage instead of merely dressing it up.
• Same steel and same section as the load bearing uprights of the range.
• Takes every CS-1 accessory, so it stays useful after each reconfiguration.
• Carries the Uni Strength logo cut into the steel.

Our guides: the 8 main benefits of a Home Gym.

Frequently asked questions

What are the specifications of the CS-1 compact logo upright?

104 cm long, 75 x 75 mm section, 3 mm thick steel, cut-out Uni Strength logo, compatible with CS-1 uprights, J-hooks, safeties and storage.

What is this upright for?

It is a structural reinforcement that adds a support point to the cage, reduces play in the structure and absorbs the vibration of heavy sets. It also serves as a mounting point for accessories, including band pegs and modular weight storage, and as an anchor point for the pulley.

Where is it placed on the rack?

On the lower or middle part of the cage, where rigidity really matters.

What assembly advice applies?

Tighten the bolts to the recommended torque and re-tighten after the first sessions, check that the crossmember is level and secured on both sides before loading the cage, and check the tightness periodically.

What is the difference with the CS-1 uprights and crossmembers?

The 236 or 204 cm uprights are the vertical parts of the cage, the 41, 76 or 104 cm CS-1 crossmembers connect the uprights, and the compact logo upright is a 104 cm crossmember that adds the Uni Strength logo. They all share the 75 x 75 mm section and the same hole standard.